This document describes how to setup an environment to access and use the Mobile Protect SDK for iOS distributed via CocoaPods. This document will take you through the steps to integrate SDK into your build system. For other guides, check out Mobile Protect Installation Guides

To fetch the Mobile Protect SDK via CocoaPods, an API key is needed. If you haven’t received an API key for Mobile Protect, please contact us.

Step 1: Add API Key to .netrc

The API key should be added to your netrc file, which will be used automatically by CocoaPods, curl and git when fetching the SDK.

Add the following entry to the file at ~/.netrc:

machine mobile-protect-repos.securetheorem.com
  password {MOBILEPROTECT_REPO_API_KEY}

Replacing {MOBILEPROTECT_REPO_API_KEY} with the Mobile Protect API key.

Step 2: Add Mobile Protect to the Podfile

In your project’s Podfile, add the dependency to the Mobile Protect SDK:

target 'MyAwesomeApp' do
  ...

  pod 'MobileProtect', '22.3.7'
end

And then run pod install to retrieve the pods for the project. See https://guides.cocoapods.org/using/the-podfile.html#specifying-pod-versions for deciding if pinning the pod versions is the best practice for your project.

Step 3: Add the Mobile Protect configuration

In the iOS project copy the MobileProtect.plist config file into the project's Xcode project, place it in the project root. See Add Existing Files and Folders to a Project for instructions.

Results

Please visit https://www.securetheorem.com/mobile/protect to see the list of your apps and the state of protection, along with the individual protection item details.